Translations:Berechnungsschema/ Implementierung der Betriebsregeln/19/en: Unterschied zwischen den Versionen
Ferrao (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „# <math>t_1 > \Delta t \,</math> (äußerer Zeitschritt) #: No range change takes place in the considered time interval. # <math>0 < t_1 < \Delta t \,</math>…“) |
Ferrao (Diskussion | Beiträge) Keine Bearbeitungszusammenfassung |
||
Zeile 4: | Zeile 4: | ||
#: There is a range change after the time <code>t<sub>1</sub></code>. The span between <code>t<sub>0</sub></code> and <code>t<sub>1</sub></code> represents the inner time step length. | #: There is a range change after the time <code>t<sub>1</sub></code>. The span between <code>t<sub>0</sub></code> and <code>t<sub>1</sub></code> represents the inner time step length. | ||
# <math>t_1 < 0 \,</math> | # <math>t_1 < 0 \,</math> | ||
#: There is no | #: There is no reservoir content increase but a decrease. Instead of the upper section limit, the lower section limit must be used and the calculation repeated. |
Version vom 21. Januar 2021, 18:43 Uhr
- [math]\displaystyle{ t_1 \gt \Delta t \, }[/math] (äußerer Zeitschritt)
- No range change takes place in the considered time interval.
- [math]\displaystyle{ 0 \lt t_1 \lt \Delta t \, }[/math]
- There is a range change after the time
t1
. The span betweent0
andt1
represents the inner time step length.
- There is a range change after the time
- [math]\displaystyle{ t_1 \lt 0 \, }[/math]
- There is no reservoir content increase but a decrease. Instead of the upper section limit, the lower section limit must be used and the calculation repeated.